Garage Door Spring Adjustment

Garage door springs offset the weight of the door and allow it to open and close with ease.

Garage door spring adjustment.

The torsion shaft powered by the spring lifts drums that easily winds cables connected with the doors at the bottom. Detach the old spring from both ends and replace it with the new one and replace the pulleys as well if they are worn out. Torsion springs must be adjusted with the door in the down position. Once the spring is free of tension remove from its track hanger.

When garage doors won t close all of the way or they close unevenly spring adjustment may be called for. How to safely adjust your garage door spring. With an extension spring door the goal is to take all the tension off the door before you even think about touching a spring you can do this by opening the door all the way and propping it up with a ladder. Be sure to have all your tools inside before closing the door unless you have an alternate access door to the garage.

This enables the opening and closing of the garage door. Adjusting garage door extension. Adjustment to torsion springs can be dangerous because they must be adjusted with the door down and the spring under tension. Garage door springs are used to offset the weight of the door.

The other is attached to a pulley connected to the cable. A problem with the spring tension could cause the door to open or close unevenly improperly or at the wrong speed and adjusting the springs will likely solve the problem. Without the springs the door is very difficult to lift. Adjusting garage door springs is a common repair.

If it was opening too quickly move it to the next lower hole. Adjust the springs on both sides of the door the same way. If the garage door isn t opening or closing properly then check the tension on the torsion springs for needed adjustments. Adjust the spring into the proper position and make sure your garage door closes all of the way.

The springs are located at the top inside part of the garage door. This can make the other parts of the garage door last a much longer time. Retest the door balance as you did in step 1. Troubleshooting garage door springs.

There are two torsion springs at each side of the garage door. Open it just as wide as you can without hitting the garage door opener s stop bolt and place a clamp on the track on both sides to keep the door in. The torsion spring helps the garage door open and close easily. One end of the spring is connected to the garage door track or frame.

Adjusting an extension spring door.