Use the flat head screwdriver to turn the spindle in the center of the door lock cylinder counterclockwise until it.
How to remove lock cylinder from door.
Remove the door lock cylinder.
Loosening the set screw will allow you to rotate the lock cylinder.
Unscrew this plate and remove the latch from the door if possible.
Look for a small set screw at the base of the handle.
Open the door and look for the latch plate along the door s edge.
Remove the spindle next you ll need to use your flat head screwdriver to turn the spindle of the lock.
With a barrel lock it s the cylinder that allows the locking and unlocking of a door.
The one presented here is a.
These screws are usually phillips head screws and hold the two.
Remove this screw using a drill or screwdriver.
Step 8 remove the steel clip or nut that secures the lock cylinder to the door.
Then pull the cylinder out of the door from the outside pushing from the inside if needed.
In most cases you will have to remove a small steel clip and pulling the actuating rod off the cylinder.
The set screw will be the screw closest to the lock cylinder on the outside of the door.
Unscrew and remove the two screws from the door lock.
Loosen the set screw near the lock itself.
Insert another flathead screwdriver under the edges of the tabs holding the lock cylinder in place within the housing.
Disconnect the actuating rod from the door lock cylinder.
Use a phillips head screwdriver to turn the set screw counterclockwise until you loosen it.
There are several types of cylinder locks.
Tools needed step 1.
How to remove cylinder door locks 1.
Insert a flatheaded screwdriver into the spindle housing hole.
How to remove a door lock without a key.