How To Remove Rear Door Panel On 2004 Chevy Suburban

Remove the trim panel upper extension.

How to remove rear door panel on 2004 chevy suburban.

My 2003 chevy suburban door locks for the 2 rear doors and the tail gate door do not work properly. Remove the trim panel from the door carefully sliding the trim panel up to release the retainers from the door. Remove the door handle bezel. Remove door lock solenoid and plug it into another door to see if it works 2.

Remove the trim panel screws. Pull drivers rear door panel off 1. Also look on side of door for possible child saftey lock switch. Remove the power accessory switch panel.

There are snaps on all three sides of the panel. Moving the whole horizontal control up or down. 2004 suburban rear doors and tailgate wont unlock with buttons. But there are 2 relays located in the i p fuse panel 1 is for lock 1 is for unlock.

Remove the speaker wire. Do the same to all the snaps. Hey everyone today s video is a quick lesson on how to remove the door panels on a 2000 2006 nbs chevy suburban tahoe silverado also gmc yukon xl cadilla. Quick instuctions for 1999 2006 2007 classic chevrolet silverado and gmc seirra 1500 2500 3500 trucks chevrolet tahoe suburban gmc yukon yukon xl.

Slide the screwdriver down until it contacts the snap and pry the snap out of the recess in the door. Place the common screwdriver at the top of the panel in between the door panel and the door. Remove the courtesy light remove door panel screws. Remove the window handle.

Raise or lower the rear of the seat cushion by raising or lowering the rear edge of the horizontal control.